(excuse us for any wrong terms, we're french) We have just received a Zmorph 2.0 SX. When we tried it for the first time, we put PLA in the extruder and opted for the PLA default-settings but when we clicked the ''feed'' button, the message ''temperature is too low'' appeared. We tried to modify the manual settings which told us that the current temperature was 0°c (wich is not likely, we tried with the dualhead and it was 24°c) and tried to set the target temperature to 200°c but every time it went back to 0°c. I think that the problem comes from the extruder's heating resistor (if that's the right term). My question is can we change the settings of the Zmorph using Voxelizer ?