Hi, just wanted to share my experience with FAST PRINTING!
eye make it bold and slanted because as you already know, 3D printing is slow as isht... so we want it to go fast ... im talk'n 300% 400% and yes even 500 po'cent fast and STILL get GOOD print QUALITY.
... or as eye like to call it "dope"
any way eye know some of you already know but, some may not know, so "if you don't know, now you know"-Biggie.
in order to make it work... you must make up for filament move and filament speed. so lets do some simple MATH <
The standard Voxelizer setting is E Move 5mm/sec & E Speed 5mm/sec at the standard 100% speed... ok so lets double it up... "math" set the E Speed and E Movee to 10mm/sec and subsequently set your print speed % to 200 >"double it up"aka simple math. continue this sequence and you get the same at the fast speeds.
simply set the E MOVE & E SPEED parameters in "head position toolbar" to make up for the speed % (percentage) at which you want to print you model > 200% 300% 400% 500% <
ON ZMORPH PRINTER PANEL:
Use your buddha finger to push the UP ARROW button to the desired %...use 100th% increments (200, 300, ect...)
**ON VOXELIZER SOFTWARE: **
set the **E MOVE and the E SPEED to same:**
10 mm/sec = 200% print speed
15 mm/sec = 300% print speed
20 mm/sec = 400% print speed
25 mm/sec = 500% print speed
eye am choosing to print at 300% therefor, eye set my E Move & E Speed to 15 mm/sec
model: "Recreus Sneaker II - Gyrobot Remixt