i have 2 spools on a Dual pro 1.75mm
-ABS white on T0 =extrude 1
-PLA red on T1 =extruder 2
eye set the model to print using the red spool located on T1 = extruder 2
then set a PLA power raft (i want to print the raft in same red PLA)
essentially i have both spools on the DualPro 1.75 extruder to print one color for each part (1 PLA red and 1 ABS white).
someone said that if i am using one color then use single extruder, but that is not my case.
don't want to swap to single head extruder > because im going to print the 2nd part with the abs)
Problem: it is building the power raft out of the ABS from extruder T0 rather than PLA as intended. (eye would like the raft to be PLA and set the lil T1 as active extruder but it starts the raft in ABS... < no good.
Question: How do eye set the the power raft to print in the red PLA instead of the white ABS.